Chinese
chinese
EnglishUnderstanding Single Phase Compensated Voltage Regulators: Essential Insights for Electrical Equipment
2024-09-09
language
中国
韩国
韩国
韩国
韩国
韩国
Guangzhou Yongxiang (Yongheng )Electrical Appliance Factory
Guangzhou Yongxiang (Yongheng )Electrical Appliance Factory
What problems should be paid attention to when applying electrostatic shielding to transformers
- Categories:FAQ
- Author:
- Origin:
- Time of issue:2022-03-14
- Views:0
(Summary description)1) The width of the electrostatic shield is equal to the winding width of the coil.
2) The copper foil with good conductivity is used, and the toroidal transformer can be wound with a layer of enameled wire.
3) Attention should be paid to the insulation of the shielding layer at the end to prevent short circuit.
4) The insulation between the shield and the winding (including creepage distance and number of insulation layers, etc.) must meet the requirements of safety standards.
5) The lead wire of the shielding layer should be well soldered, and attention should be paid to the insulation of the lead wire.
6) When shielding with copper foil, it is necessary to prevent edge burrs from damaging the insulation and causing short circuits.
What problems should be paid attention to when applying electrostatic shielding to transformers
(Summary description)1) The width of the electrostatic shield is equal to the winding width of the coil.
2) The copper foil with good conductivity is used, and the toroidal transformer can be wound with a layer of enameled wire.
3) Attention should be paid to the insulation of the shielding layer at the end to prevent short circuit.
4) The insulation between the shield and the winding (including creepage distance and number of insulation layers, etc.) must meet the requirements of safety standards.
5) The lead wire of the shielding layer should be well soldered, and attention should be paid to the insulation of the lead wire.
6) When shielding with copper foil, it is necessary to prevent edge burrs from damaging the insulation and causing short circuits.
- Categories:FAQ
- Author:
- Origin:
- Time of issue:2022-03-14
- Views:0
Information
1) The width of the electrostatic shield is equal to the winding width of the coil.
2) The copper foil with good conductivity is used, and the toroidal transformer can be wound with a layer of enameled wire.
3) Attention should be paid to the insulation of the shielding layer at the end to prevent short circuit.
4) The insulation between the shield and the winding (including creepage distance and number of insulation layers, etc.) must meet the requirements of safety standards.
5) The lead wire of the shielding layer should be well soldered, and attention should be paid to the insulation of the lead wire.
6) When shielding with copper foil, it is necessary to prevent edge burrs from damaging the insulation and causing short circuits.
Scan the QR code to read on your phone
Relevant news
Leave A Message
首页留言
描述：
Copyright ©2022 Guangzhou Yongheng ( Yongxiang) Electrical Appliance Factory All rights reserved 粤ICP备10233228号 SEO
